| Message Index | Start New Topic | Photo Gallery | FAQ and Use Tips | Bob's Rock Shop |
Posted in response to Re: Buffing Machine Plans from jay bates on August 19, 2008 at 08:12:56:
|
Nice solution, Jay! I don't do lapidary work, but I would assume that you can get different polishing speeds by where you hold the piece along the radius of the wheel. Am I correct?
From Don Peck - August 20, 2008 at 08:17:43
|
| Message Index | Start New Topic | Photo Gallery | FAQ and Use Tips | Bob's Rock Shop |
| ||||||
